Ameba DigiCap II series Manual de usuario descargar pdf (Pagina 64)

Setup relay (Fig.7-8.1)

Click “Setup relay” tab, the window as above right one will be shown. Follow the instructions

below to complete setting.

Control: You need to specify the device for setting.

No/Name: Enter “Controller name” corresponding to the desired relay number.

Duration: Enter the controller’s working period when relay trigger.

OK: Click to accept setting. Copy: Copy the parameter setting to another relay.

Cancel: Discard changes in parameter.

Fig. 7-8.3 Fig. 7-8.4

Control NetCom Module relay

Click “Control NetCom Module relay” tab on setup I/O port, as Fig.7-8.3, you can control the

relay out manually or trigger by sensors. The purpose of this tab is testing, remote controlling and

manual control controller.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 117 118

Sin comentarios

Ameba DigiCap II series Manual de usuario Pagina 64